Milesight UG65 LoRaWAN Gateway SIM card setup

Device setup Published

Set up a ThingSIM data SIM as 4G backhaul for a Milesight UG65 LoRaWAN gateway in Ireland: SIM size, plan, APN and roaming settings, and troubleshooting.

The Milesight UG65 is an indoor LoRaWAN gateway that collects readings from battery sensors and sends them on over Ethernet, Wi-Fi or 4G. On the cellular version a ThingSIM is the 4G uplink, set up in the gateway's web interface.

Specifications and menu paths checked against Milesight's own documentation on 3 November 2026; sources are listed at the end. Menus can move between firmware versions, so if yours differs, follow the manual for your version.

What the UG65 is

An 8-channel LoRaWAN gateway with a built-in network server, for buildings, farms and campuses. Cellular versions have “-L” in the model code, for example UG65-L04EU or UG65-L08GL. Milesight has announced end of life for the external-antenna UG65-L04EU-868M-EA from July 2025, with UG65-L08GL-868M-EA as its replacement.

Which ThingSIM suits the UG65

Compatible. Milesight lists LTE bands 1, 3, 7, 8, 20 and 28 for its L04EU module and a wider set including 1, 3, 7, 8 and 20 for L08GL, covering the 4G bands used by the Irish networks. The gateway takes one mini SIM (2FF), so order a physical ThingSIM and use it at the largest size. No eSIM is listed.

LoRaWAN sensor traffic is small. Most gateways fit in Ireland multi-network 250 MB at €1.29 a month; check usage in the portal after the first month, as firmware updates and remote management add to it.

Insert the SIM

  1. Activate the SIM in the ThingSIM portal when you are ready to test; billing starts that day.
  2. Power the gateway off. Milesight says the SIM slot is not hot-pluggable.
  3. Open the protective cover on the back with a screwdriver and insert the mini SIM in the correct orientation, as marked by the slot. Press the card to eject it later.
  4. Refit the cover, check the cellular antennas are connected and power the gateway on.

Set up mobile data on the UG65

  1. Log in to the gateway's web interface and go to Network → Interface → Cellular → Cellular Setting.
  2. Make sure the cellular interface is enabled. In the APN field, enter the APN shown in your ThingSIM portal when you activate the SIM, leave the username and password blank and set Authentication Type to None.
  3. Switch Roaming on. A ThingSIM connects to Irish networks as a roaming SIM and will not connect with roaming off.
  4. Leave PIN Code empty unless the SIM has a PIN set.
  5. Click Save, then Apply.

Check it is working

Status → Cellular shows the register status, the network (ISP), network type and signal level, and Network Status shows Connected. The LTE LED blinks slowly once registered and stays on once the data connection is up.

Troubleshooting

  • Registered but not connected: check that Roaming is on in Cellular Setting; it is the most common cause on Milesight gateways.
  • Unsure which module you have: the model code on the label (L04EU or L08GL) tells you; both cover the 4G bands the Irish networks use.
  • Signal but no data: check the SIM is activated in the ThingSIM portal, the APN matches the one shown in the portal exactly with no spaces, and data roaming is allowed. Then work through signal but no data in order.
  • It worked, then stopped: look at the SIM's usage in the portal. A ThingSIM pauses when it reaches its monthly allowance; upgrade the plan straight away or wait for the reset.
  • Near the border: in Donegal, Leitrim, Cavan, Monaghan or Louth a device can pick up a Northern Ireland network, which is outside the Ireland plan. Test the signal on site, and if the device may cross the border or latch on to a Northern Ireland network, see IoT SIMs for Europe and Northern Ireland.

Common questions

Does a ThingSIM work in a Milesight UG65?

Yes, in the cellular version. Insert the mini SIM, enter the APN shown in your ThingSIM portal under Network → Interface → Cellular and switch Roaming on.

How much data does a LoRaWAN gateway use?

Usually little: sensor packets are small. Start on 250 MB a month, €1.29 on the Ireland multi-network plan, and check the first month's usage in the portal.

What size SIM does the UG65 take?

A mini SIM (2FF), the largest size on the ThingSIM trio card.

Sources

Checked on 3 November 2026.

Recommended plan

Ireland multi-network, 250 MB a month

Roams across Vodafone, Three and eir and uses whichever is strongest where the device is.

About this plan

250 MB

Ireland multi-network

€1.29a month per active SIM, ex VAT

Order 250 MB

More Guides

All guides
Device setup GL.iNet GL-X3000 (Spitz AX) SIM card setup Set up a ThingSIM data SIM in a GL.iNet GL-X3000 Spitz AX in Ireland: SIM size and plan, the nano SIM, APN and roaming settings, failover and troubleshooting. Device setup Milesight UR32 Industrial Router SIM card setup Set up a ThingSIM data SIM in a Milesight UR32 4G router in Ireland: SIM size and plan, the mini SIM, APN and roaming settings, failover and troubleshooting. Device setup Netgear LM1200 SIM card setup Set up a ThingSIM data SIM in a Netgear LM1200 4G modem in Ireland: SIM size and plan, the APN profile, Auto Connect for a roaming SIM and troubleshooting. Device setup Peplink MAX BR1 Mini SIM card setup Set up a ThingSIM data SIM in a Peplink MAX BR1 Mini in Ireland: SIM size and plan, the cellular APN and data roaming, SIM A and B failover and troubleshooting.